 |
Power consumption: 150 milliamps in active mode,
35 milliamps in stand-by mode. Once the engine of the vehicle is switched off
the system will switch to stand-by mode to reduce power consumption
to a minimum. |
|
Runs on 12 to 24 volts |
|
Compiles completely separate sets of data about the operator
and the vehicle |
|
Unlimited simultaneous monitoring of several operators in
a single vehicle |
|
Fully automatic definition of the operator, driver, solo driver
or co-driver |
|
Data communication via RF, GSM or GPRS |
|
Communication protocol guarantees transmission of data |
|
In the case of GSM, data is sent via cost-saving 'GSM data'
rather than SMS |
|
Data storage back-up with the aid of an internal battery -
data storage is not affected if the battery is removed from
the vehicle |
|
Operator authorisation is checked against a programmable 'whitelist'
with data communication |
|
Parameter settings can be programmed via data communication
to ensure simple management of the entire fleet |
Startpage
Fleetlog®